Removal of cyanotoxins from surface water resources using reusable molecularly imprinted polymer adsorbents

Introduction

Microcystins (MCs; cyclic heptapeptides) are produced by freshwater cyanobacteria and cause public health concern in potable water supplies. There are more than 60 types of MCs identified to date, of which MC-LR is the most common found worldwide. For MC-LR, the WHO has established a threshold value of 1???g?L^?1 for drinking water. The present MCs removal methods such as coagulation, flocculation, adsorption, and filtration showed low efficiency for removing dissolved MC fraction from surface waters to the stipulated limit prescribed by WHO based on MC health impacts. The search for cost-effective and efficient removal method is still warranted for remediation of dissolved MC-LR-contaminated water resources.

Materials and methods

Molecularly imprinted polymer (MIP) adsorbent has been prepared using non-covalent imprinting approach. Using MC-LR as a template, itaconic acid as a functional monomer, and ethylene glycol dimethacrylate as a cross-linking monomer, a MIP has been synthesized. Computer simulations were used to design effective binding sites for MC-LR binding in aqueous solutions. Batch binding adsorption assay was followed to determine binding capacity of MIP under the influence of environmental parameters such as total dissolved solids and pH.

Results and discussion

The adsorptive removal of MC-LR from lake water has been investigated using MIPs. The MIP showed excellent adsorption potential toward MC-LR in aqueous solutions with a binding capacity of 3.64???g?mg^?1 which is about 60% and 70% more than the commercially used powdered activated carbon (PAC) and resin XAD, respectively. Environmental parameters such as total organic carbon (represented as chemical oxygen demand (COD)) and total dissolved solids (TDS) showed no significant interference up to 300?mg?L^?1 for MC-LR removal from lake water samples. It was found that the binding sites on PAC and XAD have more affinity toward COD and TDS than the MC-LR. Further, the adsorption capacity of the MIP was evaluated rigorously by its repeated contact with fresh lake water, and it was found that the adsorption capacity of the MIP did not change even after seven adsorption/desorption cycles. The contaminated water of MC-LR (1.0???g?L^?1) of 3,640?L could be treated by 1?g of MIP with an estimated cost of US $1.5.

Conclusions

The adsorption capacity of the MIP is 40% more than commercially used PAC and resins and also the polymer showed reusable potential which is one of the important criteria in selection of cyanotoxins remediation methods.     

Prenatal diagnosis of lethal osteogenesis imperfecta (OI) by ultrasonography

Ultrasonography was performed during the second trimester (17 weeks) in a pregnancy at risk for osteogenesis imperfecta congenita (OI). The scan showed that the femur was short, bent and dense. Radiologic examination of the fetus after interruption of pregnancy showed typical X-ray changes of OI.     

Characterization and modeling of nutrient-deficient tomato-processing wastewater treatment using an anaerobic/aerobic system

Tomato-processing wastewaters are typical of slowly biodegradable high strength wastewaters generated from the food canning industry. Three different samples of influent and three samples of anaerobic effluents corresponding to the three influents collected from an on-site pilot-scale anaerobic/aerobic system were characterized using respirometric methods. Respirometric studies demonstrated that the pretreatment in the anaerobic reactor of the pilot-scale system increased the readily biodegradable fraction from an average of 40% of the SCOD in the influent to 50% of the SCOD in the anaerobic effluent, improved kinetics from an average micro(max) of 1.5d(-1) in the influent to 3.5d(-1) in the anaerobic effluent, and eliminated nutrient deficiency. Furthermore, the system was calibrated and simulated by application of wastewater characterization and biokinetic data derived form respirometric tests of influent and anaerobic effluent in Activated Sludge Model no.1 (ASM1).     

Toxic responses in primary rat hepatocytes exposed with occupational dust collected from work environment of bone-based industrial unit

In this in vitro study we investigated the toxic responses in hepatocytes treated with occupational dust to which workers are exposed in bone-based industrial units. The present study investigated the toxicity mechanism of bone-based occupational dust, from a particular industrial unit, on isolated rat hepatocytes. The hepatocytes were isolated by collagenase perfusion method and cell viability was determined by trypan blue exclusion and MTT [3-(4,5-dimethyl thiazol-2-yl)-2,5-diphenyl tetrazolium bromide] assay treated with occupational dust at 0.1-1.0 mgmL(-1), for 120 min. The cell viability decreased significantly in a concentration-dependent manner. Dust induced significant membrane damage measured by lactate dehydrogenase (LDH) and glutathione (GSH) release in culture media for 30-, 60- and 120 min treatment duration. The toxicity was found to be correlated with the induction of lipid peroxidation (LPO). In addition, nitric oxide (NO), and hydrogen peroxide (H(2)O(2)) generation by occupational dusts were also found to be time- and concentration-dependent. Over all the present study provides initial evidences for the toxic potential of occupational dust generated in bone-based industries and, therefore, the dust exposure to workers in unorganized industrial units should be controlled.     

Removal of arsenate from water by adsorbents: a comparative case study

Laboratory and field filtration experiments were conducted to study the effectiveness of As(V) removal for five types of adsorbent media. The media included activated alumina (AA), modified activated alumina (MAA), granular ferric hydroxide (GFH), granular ferric oxide (GFO), and granular titanium dioxide (TiO?). In laboratory batch and column experiments, the synthetic challenge water was used to evaluate the effectiveness for five adsorbents. The results of the batch experiments showed that the As(V) adsorption decreased as follows at pH 6.5: TiO? > GFO > GFH > MAA > AA. At pH 8.5, however, As(V) removal decreased in the following order: GFO = TiO? > GFH > MAA > AA. In column experiments, at pH 6.5, the adsorbed As(V) for adsorbents followed the order: TiO? > GFO > GFH, whereas at pH 8.5 the order became: GFO = TiO? > GFH when the challenge water containing 50 μg/L of As(V) was used. Field filtration experiments were carried out in parallel at a wellhead in New Jersey. Before the effluent arsenic concentration increased to 10 μg/L, approximately 58,000 and 41,500 bed volumes of groundwater containing an average of 47 μg/L of As(V) were treated by the filter system packed with GFO and TiO?, respectively. The As(V) adsorption decreased in the following sequence: GFO > TiO? > GFH > MAA > AA. Filtration results demonstrated that GFO and TiO? adsorbents could be used as media in small community filtration systems for As(V) removal.     

Environmental control of the breeding of three boreo-arctic cirripedes

Three species of barnacles with boreo-aretic distribution were shown to require maintenance for several weeks below a critical temperature before the breeding condition could be attained. The temperatures critical for Balanus balanoides (L.) Balanus balanus (L.) and Balanus crenatus (Bruguière) were found to be between 10° and 12°C, 10° and 14°C, and at about 17°C, respectively. Although the strong influence of continuous light and the weak influence of continued feeding in delaying the onset of breeding in B. balanoides were confirmed, there remained some outstanding anomalies between the breeding behaviour of this species under laboratory conditions and between the tide marks. It was found impossible to initiate breeding by the application of conditioning procedures significantly in advance of the time of the normal Autumn breeding season in B. balanoides. Breeding appears to be inhibited, independently of external conditions, for a set period after the preceding brood cycle. Evidence points to a similar, largely endogenous, control of breeding in B. balanus which also breeds once annually, but not in B. crenatus which breeds continuously so long as food and temperature levels permit.     

A correlation of secondary aerosol (nitrate and sulfate) with respirable particulate matter (RPM) in ambient air at different traffic junctions of Vadodara city

The correlation study of secondary aerosol (nitrate and sulfate) with RPM in ambient air at different traffic junctions of Vadodara city is reported. RPM was analyzed using Ion Chromatography technique and measured the level of nitrate and sulfate in ambient air. The correlation studies of these particulates with RPM have been established. The average concentration of sulfate and nitrate in ambient air was found 35.74 microg/m3 and 24.22 microg/m3, which ranged of 5.33-84.69 and 1.93-77.86 microg/m3 respectively. The correlation of RPM and SO4 (r = 0.813, P<0.01), RPM-NO3 (r = 0.5549, P<0.01) and SO4-NO3 (r = 0.6133, P<0.01) were found significant. The presence of sulfate and nitrate in RPM is 8.25% and 5.60% . The pH of water extract of RPM averaged 6.81, which ranged 6.17-7.28. Regression analysis result showed that the relationship between RPM-SO4 was significantly (R2=0.66215) correlated. This indicate that probably the secondary aerosols such as nitrate and sulfate in excess may cause irritation and increasing lung disease.     

The chemical form of cobalt-60 in the marine sponge Spirastrella cuspidifera

The marine sponge Spirastrella cuspidifera Lamarck shows a remarkable capacity to concentrate cobalt-60 from its environment, the specific activity of the radionuclide being two orders of magnitude higher than that in the ambient water. This suggests a very slow equilibrium with stable cobalt. The chemical form of the deposited cobalt-60 has been investigated in S. cuspidifera collected from coastal waters in the vicinity of a nuclear power station. The majority of the cobalt-60, 75 to 85%, is readily extractable into distilled water. Chromatographic analysis of this soluble fraction shows that about 85% of the cobalt is present as a small-molecular weight complex of low stability. No binding to any specific protein could be identified. The possible mechanism for the preferential uptake of cobalt-60 by this species of sponge is discussed.     

Polycyclic Aromatic Hydrocarbons: Need for Assessment of Health Risks in India? Study of An Urban-Industrial Location in India

This paper reports the PAHs levels in the atmosphere of an urbanised industrial site of India. A high-resolution capillary gas chromatograph with a mass spectrometric detector (HRCGC-MS) and a high performance liquid chromatograph (HPLC) equipped with a fluorescence detector were used for the identification and quantitation of PAHs. The atmospheric levels of PAHs were higher (4.66 ng/m³ yearly average) than most of the concentrations previously reported in the literature. Indian sites were found more contaminated with potently carcinogenic: four and above ringed PAHs. Based on a good correlation between the levels of lead, vanadium, BaP and BghiP, the vehicular emission appears to be a major source of the PAHs. Further, the higher levels of observed PAHs could be attributed to the vertical distribution of the aerosols, the preference of the PAHs for the particulate phase and the greater availability of the substrate in the atmosphere for their sorption. This paper also discusses the need for development of a PAHs monitoring protocol and related health effect studies in developing countries such as India.